Volume 9, Issue 1 (march 2012 2012)                   IJMSE 2012, 9(1): 42-50 | Back to browse issues page

XML Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
M. Zandrahimi, A. Rezvanifar. THE INFLUENCE OF DRY SLIDING ON PRCIPITATION HARDENING BEHAVIORS OF Al-Cu-Si ALLOY. IJMSE 2012; 9 (1) :42-50
URL: http://ijmse.iust.ac.ir/article-1-410-en.html
THE INFLUENCE OF DRY SLIDING ON PRCIPITATION HARDENING BEHAVIORS OF Al-Cu-Si ALLOY
M. Zandrahimi , A. Rezvanifar
Abstract:   (21850 Views)
Abstract: Cold working performed before an aging treatment has a significant effect on size and amount of precipitate produced. This could be caused by the increase in defect density, such as vacancies and dislocations. In this research, the Al-Cu-Si alloy was solution-treated, wear-tested and then artificially aged for a period of 1–5 h. Changes in the amount of precipitate, in the lattice parameter of the matrix, and in the precipitates are measured by X-ray diffraction and then calculated.It was observed that performing a wear test before the aging treatment was done significantly increased the amount of precipitate, while wear rate decreased.
Keywords: Dry sliding, X-ray diffraction, lattice parameter, mass fraction
Full-Text [PDF 569 kb]   (5153 Downloads)    
Type of Study: Research Paper | Subject: Ceramics
Add your comments about this article : Your username or Email:
CAPTCHA
Send email to the article author

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb