Volume 2, Issue 1 (Oct 2005)                   IJMSE 2005, 2(1): 9-15 | Back to browse issues page

XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

KHARAZI Y.H.K., DIVANDARI M.. MOLD FILLING BEHAVIOR OF DOUBLE GATING SYSTEM IN ALUMINUMLFC PROCESS. IJMSE 2005; 2 (1) :9-15
URL: http://ijmse.iust.ac.ir/article-1-45-en.html
Abstract:   (30469 Views)
The mold-filling behavior in the casting of aluminum alloy (A413) using lost foam casting (LFC) was explored. The effects of gate numbers, type of gating and casting thickness on the filling behavior were evaluated. Although, unlike convectional casting process, the gating system showed little effect onfilling ability, casting thickness created a greater effect on the mold filling. In contrast with convectional casting process, the mold filling seems to be controlled by castinggeometry as a consequence of combined influence of heat and mass transfer. The melt used to enter from the first gate instead of last gate which is in contrast with convectional casting process.
     
Type of Study: Research Paper | Subject: Ceramics

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb