Iranian Journal of Materials Science and Engineering
Iran University of Science & Technology
Mon, Nov 11, 2024
[Archive]
Volume 12, Issue 3 (September 2015)
IJMSE 2015, 12(3): 14-26 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Salimi A, Özdemir A, Erdem A. SIMULATION AND MONITORING OF THE MACHINING PROCESS VIA FUZZY LOGIC AND CUTTING FORCES. IJMSE 2015; 12 (3) :14-26
URL: http://ijmse.iust.ac.ir/article-1-826-en.html
URL: http://ijmse.iust.ac.ir/article-1-826-en.html
Abstract: (21695 Views)
On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems
(FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in
turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded
as the output data in the fuzzy logic for constructing the system. Flank wear was used as the tool life criterion and the
wear ranges were selected between 0 and 0, 3 based on ISO 3685 standard for new and worn tool respectively. For
conducting the tests, Taghuchi method was used to design an experimental table. The results of the measurements and
estimates confirmed the reliability of the fuzzy logic method for estimating tool wear. One significant feature of the
proposed system is that it can predict the wear rate on-line by transferring the cutting force signals from the sensor to
the fuzzy logic simulation box.
Type of Study: Research Paper |
Subject:
forming and mechanical properties
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
